yperk

Advanced Firmware Flasher

ESP32 / ESP8266

Select hardware to flash
Raspberry Pi Pico (UF2)

Pico requires manual flashing via USB Drive mode.

Instruction for Pico
  1. Hold BOOTSEL button.
  2. Connect Pico to USB.
  3. Release button when RPI-RP2 drive appears.
  4. Drag & drop the .uf2 file to the drive.
What's next? (Post-Flash Setup)

After successful flashing, follow these steps to configure your device:

  1. Connect to AP: Look for a Wi-Fi network named "Hyperk-Setup" and connect.
  2. Configuration: A settings page should open automatically (or go to 192.168.4.1).
  3. Wi-Fi setup: Enter your home Wi-Fi SSID and Password, then Save.
  4. Reboot: The device will restart and connect to your network.
Fail-safe mechanism: If the device cannot connect within 12 seconds, it will automatically return to Access Point mode.